How to Use Wismec Bellerophon RTA - User Manual
Bellerophon RTA Instruction?
1. RTA Building
① Make sure you hands are clean before building
② Take the atomizer base apart
③ Install the pre-wrapped coil
After installing the coil, heat the coil and then cool it down. ④ Install the moderate cotton Cut a strip of cotton and place it the middle. Cut the wick to some extent and make sure it is not too long or too short. ⑤ Use the e-liquid to make your coil wet and adjust the wick.
2. E-liquid Filling ① Hold the tank with one hand and use the other to screw off its drip tip and top cap ② Please hold the tank at a 45 degree angle, add e-liquid through two slots, and pay attention not to drip into the central airflow tube; ③ Close the tap carefully and firmly. Wait for several minutes to get the organic cotton completely saturated
3. Airflow Adjustment You can adjust the airflow freely by swiveling the airflow ring on the bottom.
Warranty
Please consult with your Wismec distributors for warranty policy. We are not responsible for any damage caused by user error. This warranty is only valid for authentic Wismec products within 90 days warranty period from the date of purchase by the end user.Warning
1. Keep out of reach of children.2. This item is not recommended for use by young people, non-smokers, pregnant or breast-feeding women, persons who are allergic/sensitive to nicotine.
Contra-indication
1. Please only have your product repaired by Wismec. Do not attempt to repair the unit by yourself as damage or personal injury may occur. 2. Do not leave the product in high temperature or damp conditions, as this may damage the product. The appropriate operation temperature is within 0℃ to 45℃ while charging and -10℃ to 60℃ while in use. 3. Keep away from water.
Possible adverse effects
1. Using this product may cause damage to health. 2. For people with adverse reaction after using this product, it is recommended to use the juice with lower nicotine content or no nicotine.
Post A Comment
No comments :